HP MSR2000 Configuration Manual page 125

Figure 32 Network diagram
Table 7 Interface and IP address assignment
Device
Router A
Router B
Router D
Configuration procedure
1. Configure IP addresses and masks for interfaces. (Details not shown.)
2. Configure IS-IS to advertise interface addresses, including the loopback interface address. (Details
not shown.)
3. Configure an LSR ID, and enable MPLS, MPLS TE, and RSVP-TE on each router. Enable BFD for
RSVP-TE on Router B and Router C:
# Configure Router A.
<RouterA> system-view
[RouterA] mpls lsr-id 1.1.1.1
[RouterA] mpls te
[RouterA-te] quit
[RouterA] rsvp
Interface IP address
Loop0 1.1.1.1/32
GE2/1/1 2.1.1.1/24
Loop0 2.2.2.2/32
GE2/1/1 2.1.1.2/24
GE2/1/2 3.1.1.1/24
POS2/2/0 3.2.1.1/24
Loop0 4.4.4.4/32
GE2/1/1 4.1.1.2/24
Device Interface
Router E Loop0
POS2/2/0
POS2/2/1
Router C Loop0
GE2/1/1
GE2/1/2
POS2/2/0
116
IP address
5.5.5.5/32
3.2.1.2/24
3.3.1.1/24
3.3.3.3/32
4.1.1.1/24
3.1.1.2/24
3.3.1.2/24