Configuring An Ldp Pw - HP MSR2000 Configuration Manual

Verifying the configuration
# Display L2VPN PW information on PE 1. The output shows that a static PW has been established.
[PE1] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpna
Peer
192.3.3.3
# Display L2VPN PW information on PE 2. The output shows that a static PW has been established.
[PE2] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpna
Peer
192.2.2.2
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)

Configuring an LDP PW

Network requirements
Create an LDP PW between PE 1 and PE 2 over the backbone so CE 1 and CE 2 can communicate with
each other.
Figure 100 Network diagram
Table 36 Interface and IP address assignment
Device
CE 1
PE 1
PW ID In/Out Label
3 100/200
PW ID In/Out Label
3 200/100
Interface IP address
GE2/1/1 100.1.1.1/24
Loop0 192.2.2.2/32
GE2/1/1 -
GE2/1/2 10.1.1.1/24
Proto Flag
Static M
Proto Flag
Static M
Device Interface
P Loop0
GE2/1/1
GE2/1/2
PE 2 Loop0
397
Link ID State
0 Up
Link ID State
0 Up
IP address
192.4.4.4/32
10.1.1.2/24
10.2.2.2/24
192.3.3.3/32