HP MSR2000 Configuration Manual page 320

Step
9. (Optional.)
filtering of received routes.
2. Configure the CE:
Step
1. Enter system view.
2. Enter BGP view.
3. Configure the PE as an EBGP
peer.
4. Create the BGP IPv6 unicast
address family and enter its
view.
5. Enable IPv6 unicast route
exchange with the specified
peer or peer group.
6. (Optional.) Configure route
redistribution.
Configuring IBGP between a PE and a CE
Use IBGP between PE and CE only in a basic IPv6 MPLS L3VPN network. In networks such as inter-AS
VPN and carrier's carrier, you cannot configure IBGP between PE and CE.
Configure the PE:
1.
Step
1. Enter system view.
2. Enter BGP view.
3. Enter
view.
4. Configure the CE as the VPN
IBGP peer.
5. Create the BGP-VPN IPv6
unicast family and enter its
view.
Command
filter-policy { acl6-number |
Configure
prefix-list ipv6-prefix-name }
import
Command
system-view
bgp as-number
peer { group-name |
ipv6-address } as-number
as-number
address-family ipv6 [ unicast ]
peer { group-name | ip-address }
enable
import-route protocol
[ { process-id | all-processes }
[ allow-direct | med med-value |
route-policy route-policy-name ]
* ]
Command
system-view
bgp as-number
BGP-VPN instance
ip vpn-instance
vpn-instance-name
peer { group-name |
ipv6-address } as-number
as-number
address-family ipv6 [ unicast ]
Remarks
By default, the PE does not filter
received routes.
Remarks
N/A
N/A
By default, no BGP peer is
configured.
By default, the BGP IPv6 unicast
address family is not created.
By default, BGP does not
exchange IPv6 unicast routes
with any peer.
A CE must advertise its VPN
routes to the connected PE so that
the PE can advertise them to the
peer CE.
Remarks
N/A
N/A
Configuration commands in
BGP-VPN instance view are the
same as those in BGP view. For
more information, see Layer
3—IP Routing Configuration
Guide.
By default, no BGP peer is
created.
By default, the BGP-VPN IPv6
unicast family is not created.
311