Configuring A Static Pw - HP MSR2000 Configuration Manual

# Configure the default next hop IP address as 10.1.1.1 on GigabitEthernet 2/1/1 (the interface
connected to CE 1). This interface does not need an IP address.
[PE] interface gigabitethernet 2/1/1
[PE-GigabitEthernet2/1/1] default-nexthop ip 10.1.1.1
[PE-GigabitEthernet2/1/1] quit
# Configure the IPCP proxy IP address as the IP address of CE 1 on Serial 2/1/0 (the interface
connected to CE 2). This interface does not need an IP address.
[PE] interface serial 2/1/0
[PE-Serial2/1/0] link-protocol ppp
[PE-Serial2/1/0] ppp ipcp proxy 10.1.1.1
[PE-Serial2/1/0] quit
# Create a cross-connect group named vpn1, create a cross-connect named vpn1 in the group,
enable interworking for the cross-connect, and bind GigabitEthernet 2/1/1 to Serial 2/1/0 on
the cross-connect.
[PE] xconnect-group vpn1
[PE-xcg-vpn1] connection vpn1
[PE-xcg-vpn1-vpn1] interworking ipv4
[PE-xcg-vpn1-vpn1] ac interface gigabitethernet 2/1/1
[PE-xcg-vpn1-vpn1] ac interface serial 2/1/0
[PE-xcg-vpn1-vpn1] quit
[PE-xcg-vpn1] quit
Verifying the configuration
# Display AC forwarding entries on PE. The output shows two AC forwarding entries.
[PE] display l2vpn forwarding ac
Total number of cross-connections: 1
Total number of ACs: 2
AC
GE2/1/1
S2/1/0
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)

Configuring a static PW

Network requirements
Create a static PW between PE 1 and PE 2 over the backbone so CE 1 and CE 2 can communicate with
each other.
Xconnect-group
vpn1
vpn1
393
Link ID
0
1