Configuring Routing Between An Mce And A Vpn Site - HP MSR2000 Configuration Manual

MCE-PE routing configuration.
•
On the PE, do the following:
Disable routing loop detection to avoid route loss during route calculation.
•
Disable route redistribution between routing protocols to save system resources.
•
Before you configure routing on an MCE, configure VPN instances, and bind the VPN instances to the
interfaces connected to the VPN sites and the PE.

Configuring routing between an MCE and a VPN site

You can configure static routing, RIP, OSPF, IS-IS, EBGP or IBGP between an MCE and a VPN site.
Configuring static routing between an MCE and a VPN site
An MCE can reach a VPN site through a static route. Static routing on a traditional CE is globally
effective and does not support address overlapping among VPNs. An MCE supports binding a static
route to a VPN instance, so that the static routes of different VPN instances can be isolated from each
other.
To configure a static route to a VPN site:
Step
1. Enter system view.
2. Configure a static route
for a VPN instance.
3. (Optional.)
the default preference
for static routes.
Configuring RIP between an MCE and a VPN site
A RIP process belongs to the public network or a single VPN instance. If you create a RIP process without
binding it to a VPN instance, the process belongs to the public network. Binding RIP processes to VPN
instances can isolate routes of different VPNs. For more information about RIP, see Layer 3—IP Routing
Configuration Guide.
To configure RIP between an MCE and a VPN site:
Step
1. Enter system view.
Command
system-view
ip route-static vpn-instance s-vpn-instance-name
dest-address { mask-length | mask } { interface-type
interface-number [ next-hop-address ] |
next-hop-address [ public ] [ track track-entry-number ]
| vpn-instance d-vpn-instance-name next-hop-address
[ track track-entry-number ] } [ permanent ]
[ preference preference-value ] [ tag tag-value ]
[ description description-text ]
Configure
ip route-static default-preference
default-preference-value
Command
system-view
207
Remarks
N/A
By default, no static
route is configured.
Perform this
configuration on the
MCE. On the VPN
site, configure a
common static route.
The default preference
is 60.
Remarks
N/A