HP MSR2000 Configuration Manual page 222

Configuring RIP between an MCE and a PE
Step
1. Enter system view.
2. Create a RIP process for
a VPN instance and
enter RIP view.
3. Enable
interface attached to the
specified network.
4. Redistribute
routes.
5. (Optional.)
the default
redistributed routes.
Configuring OSPF between an MCE and a PE
Step
1. Enter system view.
2. Create an OSPF process for a
VPN instance and enter OSPF
view.
3. Disable routing loop detection.
4. (Optional.)
OSPF domain ID.
5. Redistribute the VPN routes.
6. (Optional.) Configure filtering
of advertised routes.
7. (Optional.)
default
redistributed routes (cost, route
number, tag, and type).
8. Create an OSPF area and
enter OSPF area view.
Command
system-view
rip [ process-id ] vpn-instance
vpn-instance-name
RIP on the
network network-address
import-route protocol [ process-id |
the VPN
all-processes | allow-ibgp ] [ allow-direct |
cost cost | route-policy route-policy-name |
tag tag ] *
Configure
cost for
default cost value
Command
system-view
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
vpn-instance-capability simple
Configure the
domain-id domain-id [ secondary ]
import-route protocol [ process-id
| all-processes | allow-ibgp ]
[ allow-direct | cost cost |
route-policy route-policy-name |
tag tag | type type ] *
filter-policy { acl-number |
prefix-list prefix-list-name } export
[ protocol [ process-id ] ]
Configure the
parameters for
default { cost cost | tag tag | type
type } *
area area-id
213
Remarks
N/A
N/A
By default, RIP is disabled on
an interface.
By default, no routes are
redistributed into RIP.
The default cost is 0.
Remarks
N/A
N/A
By default, routing loop detection
is enabled.
You must disable routing loop
detection for a VPN OSPF process
on the MCE. Otherwise, the MCE
cannot receive OSPF routes from
the PE.
The default domain ID is 0.
By default, no routes are
redistributed into OSPF.
By default, redistributed routes are
not filtered.
The default cost is 1, the default tag
is 1, and default type of
redistributed routes is Type-2.
By default, no OSPF area is
created.