HP MSR2000 Configuration Manual page 349

[PE1] mpls ldp
[PE1-ldp] quit
[PE1] interface pos 2/1/0
[PE1-Pos2/1/0] mpls enable
[PE1-Pos2/1/0] mpls ldp enable
[PE1-Pos2/1/0] quit
# Configure basic MPLS on ASBR-PE 1, and enable MPLS LDP for both ASBR-PE 1 and the interface
connected to PE 1.
<ASBR-PE1> system-view
[ASBR-PE1] mpls lsr-id 2.2.2.9
[ASBR-PE1] mpls ldp
[ASBR-PE1-ldp] quit
[ASBR-PE1] interface pos 2/1/0
[ASBR-PE1-Pos2/1/0] mpls enable
[ASBR-PE1-Pos2/1/0] mpls ldp enable
[ASBR-PE1-Pos2/1/0] quit
# Configure basic MPLS on ASBR-PE 2, and enable MPLS LDP for both ASBR-PE 2 and the interface
connected to PE 2.
<ASBR-PE2> system-view
[ASBR-PE2] mpls lsr-id 3.3.3.9
[ASBR-PE2] mpls ldp
[ASBR-PE2-ldp] quit
[ASBR-PE2] interface pos 2/1/0
[ASBR-PE2-Pos2/1/0] mpls enable
[ASBR-PE2-Pos2/1/0] mpls ldp enable
[ASBR-PE2-Pos2/1/0] quit
# Configure basic MPLS on PE 2, and enable MPLS LDP for both PE 2 and the interface connected
to ASBR-PE 2.
<PE2> system-view
[PE2] mpls lsr-id 4.4.4.9
[PE2] mpls ldp
[PE2-ldp] quit
[PE2] interface pos 2/1/0
[PE2-Pos2/1/0] mpls enable
[PE2-Pos2/1/0] mpls ldp enable
[PE2-Pos2/1/0] quit
# Each PE and the ASBR-PE in the same AS can establish an LDP neighbor relationship. Execute the
display mpls ldp session command on the routers to verify that the session status is Operational.
(Details not shown.)
3. Configure a VPN instance on the PEs:
For the same VPN, the route targets for the VPN instance on the PE must match those for the VPN
instance on the ASBR-PE in the same AS. This is not required for PEs in different ASs.
# Configure CE 1.
<CE1> system-view
[CE1] interface gigabitethernet 2/1/1
[CE1-GigabitEthernet2/1/1] ipv6 address 2001:1::1 96
[CE1-GigabitEthernet2/1/1] quit
340