HP MSR2000 Configuration Manual page 321

Step
6. Enable IPv6 unicast route
exchange with the specified
peer.
7. Configure the CE as a client
of the RR.
8. (Optional.) Enable
reflection between clients.
9. (Optional.) Configure
cluster ID for the RR.
2. Configure the CE:
Step
1. Enter system view.
2. Enter BGP view.
3. Configure the PE as an IBGP
peer.
4. Create the BGP IPv6 unicast
family and enter its view.
5. Enable IPv6 unicast route
exchange with the specified
peer or peer group.
6. (Optional.) Configure route
redistribution.
Command
peer { group-name |
ipv6-address } enable
peer { group-name |
ipv6-address } reflect-client
route
reflect between-clients
the
reflector cluster-id { cluster-id |
ip-address }
Command
system-view
bgp as-number
peer { group-name |
ipv6-address } as-number
as-number
address-family ipv6 [ unicast ]
peer { group-name |
ipv6-address } enable
import-route protocol
[ { process-id | all-processes }
[ allow-direct |med med-value |
route-policy route-policy-name ]
* ]
312
Remarks
By default, BGP does not
exchange IPv6 unicast routes
with any peer.
By default, no RR or RR client is
configured, and the PE does not
advertise routes learned from the
IBGP peer CE to other IBGP
peers, including VPNv6 IBGP
peers. The PE advertises routes
learned from the CE to other
IBGP peers only when you
configure the IBGP peer CE as a
client of the RR.
Configuring an RR does not
change the next hop of a route.
To change the next hop of a
route, configure an inbound
policy on the receiving side.
By default, route reflection
between clients is enabled.
By default, the RR uses its own
router ID as the cluster ID.
If multiple RRs exist in a cluster,
use this command to configure
the same cluster ID for all RRs in
the cluster to avoid routing loops.
Remarks
N/A
N/A
By default, no BGP peer is
created.
By default, the BGP IPv6 unicast
family is not created.
By default, BGP does not
exchange IPv6 unicast routes
with any peer.
A CE must redistribute its routes
to the PE so the PE can advertise
them to the peer CE.