Run - HP 54501A Programming Reference Manual

RUN
RUN
command
The
RUN
command acquires data for the active waveform display. The
data
is
acquired in the manner defined
by
the timebase mode.
If
the timebase mode
is
in SINGLE, the
RUN
command enables the
trigger
once and
displays the acquired data
on the CRT.
This
also
occurs
when the front panel
SINGLE key is pressed when the instrument
is
STOPPED.
If
the timebase mode is
AUTO
or
TRIGGERED,
the
RUN
command
will enable the trigger repeatedly and
display the
data
it acquires
continuously on the
CRT.
This is
the same thing that happens when the
front panel
RUN key
is pressed. See the
:TIMEBASE:MODE
command
for
a
description of the
various modes.
Command Syntax: :RUN
Example:
OUTPUT 707;":RUN"
HP 54501A
Programming
Root Level Commands
6-15