Replacing The System Cover - HPE AlphaServer 300 User Manual

Replacing the System Cover

After you have finished adding options, follow these steps:
1. Check all cable connections to ensure that the connectors are firmly seated.
________________________ CAUTION___________________________
After adding options, you might wish to test the system with the cover off in
case you need to reconfigure jumpers or switches. Take care not to run the
system without the cover for an extended time, because you risk damage from
overheating.
____________________________________________________________
2. Position all cables so that they will not be pinched by the cover.
3. Replace the system cover and slide it forward to engage it. Be careful to ensure that
the gaskets at all edges are properly mated before you fully seat the cover.
4. Lock the system cover, as Figure 4-23 shows.
Installing System Options 4-27