HPE AlphaServer 300 User Manual page 46

__________________________NOTE ____________________________
Type information carefully. If you make a typing error, you cannot correct it.
Type Ctrl/X to exit the utility. Then type iconfig and begin again. To delete an
entry you created, position the cursor on the first column of the entry and press
the Backspace key.
____________________________________________________________
To add a second ISA option, type iconfig at the >>> console prompt. Enter the device
name, then tab to the next field and enter the I/O address, and so forth. For example, to
add a second DE205 Ethernet controller to the database, follow these steps:
1. Enter up to 15 chars device name
2. Enter I/O address in hex
3. Enter IRQ channel in decimal
4. Enter dma channel in decimal
5. Enter memory address in hex
6. Enter length of memory in hex
7. Enter N to disable, Y to enable
8. Initialize the system.
9. View the new entry
10. Turn off the system and install the new module.
__________________________NOTE ____________________________
The available IRQ values for ISA options are 5, 9, 10, 14, and 15. On Windows
NT systems, IRQs 9, 10, 11, and 15 are preassigned to PCI options, if such
options are installed.
____________________________________________________________
If IRQ conflicts exist, a message is displayed. For example, if you entered an IRQ value
of 8 instead of 5, the following message is displayed:
ISACFG MESSAGE:
(0,2,8,11 or 13)
If you entered a DMA value of 2 rather than nothing, the following message is displayed:
ISACFG MESSAGE:
ERROR: IRQ conflict with reserved IRQ values
ERROR: DMA conflict with slot 0 dev 5
DE200-LE [TAB]
300 [TAB]
5 [TAB]
[TAB]
d0000 [TAB]
10000 [TAB]
Y [RETURN]
>>>init
>>>iconfig
Console Commands 3-19