Setting System Parameters; Set Default Environment Variables; Set Default Configuration - HPE AlphaServer 300 User Manual

Setting System Parameters

Set Default Environment Variables

The "Set default environment variables" command is located in the Setup menu. Use this
command to specify the location of the default system partition. Press ESC to return to the
previous menu.
Enter location of default system partition:
Select media:
SCSI Hard Disk
Floppy Disk
CD-ROM
Enter SCSI bus number: 0
Enter SCSI ID: 0
Enter partition [must be FAT or NTFS]: 1

Set Default Configuration

The "Set default configuration" command is located in the Setup menu. Use this
command to select monitor resolution, floppy drive capacity, keyboard language, and
SCSI controller (Host) ID.
Select monitor resolution:
1280x1024
1024x768
800x600
640x480
Select floppy drive capacity:
5.25" 1.2MB
3.5" 1.44MB
3.5" 2.88MB
Select second floppy drive capacity:
5.25" 1.2MB
3.5" 1.44MB
3.5" 2.88MB
None
Select keyboard:
U.S.
Japanese
French
German
Spanish
.
.
.
Enter SCSI Host ID (0-7) for SCSI bus number 0: 7
3-6 AlphaServer 300 User's Guide
101-key keyboard
106-key keyboard
102-key keyboard
102-key keyboard
102-key keyboard