Removing The Top Cover - HPE AlphaServer 300 User Manual

Removing the Top Cover

To remove the top cover, perform the following steps:
1. Turn off your system and all peripheral devices.
2. Unplug the power cord and remove the monitor power cord (if connected) and video
cable.
3. Unlock the top cover by turning the key counterclockwise.
__________________________ HINT _____________________________
Occasionally, the top cover of the system is pushed back during shipping. This
can cause a misalignment of the locking mechanism, which makes operating the
key lock difficult. To remedy this, push the top cover toward the bezel; this
aligns the cover, allowing you to operate the key lock properly.
____________________________________________________________
_______________________ CAUTIONS __________________________
1. To avoid system damage from static discharge, touch bare (unpainted) metal
on the system box before you touch anything inside the system.
2. To avoid system damage from overheating, be careful not to run the system
without the top cover in place for extended periods of time.
____________________________________________________________
4. To remove the cover, place your thumbs on the upper corners of the rear panel, pull
back on the cover sides, and lift the cover off.
4-2 AlphaServer 300 User's Guide