Expansion Card -Synqnet; Front View; Node Id Switch; Node Led Table - Kollmorgen SERVOSTAR 640 Instruction Manual

Expansion Cards
10.7

Expansion card -SYNQNET-

This section describes the SynqNet expansion card for SERVOSTAR 640/670.
Information on the range of functions and the software protocol can be found in the SynqNet docu-
mentation..
10.7.1

Front view

10.7.2

NODE ID Switch

With these hexadecimal switches you can set the main and low significant bytes of the Node ID
seperately. SynqNet does not require an address for correct operation in the network, however in
some machines this can be a convenient way of identifying build options to the application program.
10.7.3

Node LED table

LED#
LED1, green
LED2, yellow
LED3, green
LED4, yellow
10.7.4

SynqNet Connection, Connector X21B/C (RJ-45)

Connection to the SynqNet network via RJ-45 connectors (IN and OUT ports) with integrated LEDs.
108
12/2010
Name Function
ON = receive valid (IN port)
LINK_IN
OFF= not valid, power off, or reset.
ON = network cyclic
CYCLIC BLINK = network not cyclic
OFF = power off, or reset
ON = receive valid (OUT port)
LINK_OUT
OFF = not valid, power off, or reset
ON = repeater on, network cyclic
REPEATER BLINK = repeater on, network not cyclic
OFF = repeater off, power off, or reset
SERVOSTAR
LED2 LED1 LED4 LED3
®
640/670 Instructions Manual
Kollmorgen