Appendix Gip68 Connector Handling; Figure 122: Ip68 Connector - Applanix POS MV V5 Installation And Operation Manual

Table of Contents

Advertisement

Appendix G IP68 Connector Handling
Handling Instructions
The connector should not be exposed to long term heat or sunshine.
If this occurs, and the connectors are very dry, soak in fresh water before use.
Ensure the connectors are lubricated - the recommended lubricant is Loctite 8021 as a spray or
Molykote 44 Medium as a paste - use either sparingly.
Any accumulation of sand or mud in the female contact should be removed with fresh water. Spraying
or the application of grease could dammage the the female seals; see Figure 122.
Do not over tighten the bulkhead nuts
Do not disconnect by pulling on the
cable and avoid sharp bends at cable
entry.
When disconnecting, pull straight, not
at an angle.
Ensure the above points are fulfilled to get
the best out of your connectors. If in doubt,
please contact Applanix.
Copyright © Applanix Corporation, 2017
POS MV V5 Installation and Operation Guide
IP68
Connector Handling

Figure 122: IP68 Connector

G-1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the POS MV V5 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Pos mv v5-1Pos mv v5-2

Table of Contents

Save PDF