Figure 18: Posview Pos Internet Address - Applanix POS MV V5 Installation And Operation Manual

Table of Contents

Advertisement

POS MV V5 Installation and Operation Guide
System
Configuration
f)
Note the original IP address of the controlling PC so that you can change it back once you have
changed the PCS address.
g) Change the IP address of the controlling PC to one that has the same network identity as the
PCS. Set a new and unique address for the controlling PC (e.g. set the PC to IP address
129.100.1.230).
h) For some versions of Windows
rebooted the PC - Exit Windows
power-on the PC again.
i)
Run Windows
j)
On MV-POSView menu bar, select Settings, Installation, POS IP Address and insert a new IP
address and/or subnet mask, see Figure 18. The new address must be valid for the network on
which you will operate the PCS. Press the OK button.
k) The new IP address for the PCS will take effect immediately and a 'Lost connection with POS'
message is displayed at the controlling PC.
l)
At the controlling PC, select File, Exit (or press the Alt, F4 keys) to exit the MV-POSView
Controller program.
m) Follow the instructions in steps e) and g) above and reset the controlling PC to its original IP
address.
n) Exit Windows
new IP addresses become active during the PC reboot sequence.
o) At completion of the reboot sequence:
The IP address of the PCS is set to be compatible with your network
The original IP address to the controlling PC is restored
4-6
®
, the new IP address does not become active until you have
®
and power-off the controlling PC; wait thirty seconds and
®
and start MV-POSView. In MV-POSView, select Tools, Connect.

Figure 18: POSView POS Internet Address

®
and power-off the controlling PC. Wait thirty seconds and power-on the PC. The

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the POS MV V5 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Pos mv v5-1Pos mv v5-2

Table of Contents

Save PDF