3. TrueHeave data may be used two ways:
a) To adjust the real-time heave parameters to improve the real-time data available on the COM
ports
b) To log the TrueHeave data for post-mission processing
4. Refer to the Data Logging procedures on page 5-10, noting the following points:
a) Select the 111 Heave data and 113 Heave data quality control check boxes in the Ethernet
Logging Control window
b) Since there is a three-minute delay between real-time and the calculation of the equivalent
TrueHeave solution, logging must continue for at least three minutes past the end of the
survey session or line
Following the survey, the TrueHeave data may be analysed offline by third party post-processing
software. Contact Applanix for a list of software packages which currently provide support for TrueHeave,
refer to page A-1.
Copyright © Applanix Corporation, 2017
POS MV V5 Installation and Operation Guide
Figure 54: POSView Status and Accuracy Panes
TrueHeave
Operation
6-3
Need help?
Do you have a question about the POS MV V5 and is the answer not in the manual?