Table of Contents
Advertisement
Kollmorgen
5.0 INSTALLATION
5.1 U
NPACKING AND
Open the box and remove all the contents. Check to ensure there is no visible damage to any
of the equipment.
Use proper procedures when handling electronic
components to avoid damage to equipment.
CAUTION
Remove all packing material and equipment from the
shipping container. Be aware that some connector kits and
CAUTION
other equipment pieces may be quite small and can be
accidentally discarded. Do not dispose of shipping materials
until the packing list has been checked.
Upon receipt of the equipment, inspect components to
ensure that no damage has occurred in shipment. If damage
NOTE
is detected, notify the carrier immediately. Check all
shipping material for connector kits, documentation,
diskettes, CD-ROM, or other small pieces of equipment.
5.2 M
OUNTING
The S200 drives are designed for operation in a cabinet using the following installation
instructions:
Mount the drives vertically inside a cabinet on a flat, solid, electrically conductive, mounting
surface connected to PE (protective earth ground) and capable of supporting the weight of the
unit.
Provide a good connection to PE. Remove the paint on the mounting surface over an area
extending at least 12 mm (0.5 in) from the mounting bolts to achieve good electrical connection
over a large area between the drive and grounded mounting surface.
Ensure the environment within the cabinet meets the requirements listed in the environmental
specifications table.
S200 Position Node Installation Guide
4/13/2012
I
NSPECTING
Installation
21
Advertisement
Table of Contents
