Table of Contents
Advertisement
Regulatory Information
2. Avoid Unexpected Motion
Always remove power from J1 and wait 5 minutes before working on the machine or
working anywhere where injury can occur due to machine motion.
CAUTION
3. Avoid Electrical Shock
CAUTION
4. Avoid Burns
The temperature of the drive's heat sink and housing as well as an external regen resistor
may exceed 60° C. Therefore, there is a danger of severe burns if these regions are
CAUTION
touched.
5. Prevent Damage to the Drive
Follow these guidelines to prevent damage to the servo drive during operation:
B.10
EMC C
Use in a Domestic Environment
The products covered in this manual are of the restricted
sales distribution class according to IEC 61800-3. In a
domestic environment this product may cause radio
WARNING
interference in which case the user may be required to take
adequate measures.
Because applications differ, it is impossible for the drive
manufacturer to guarantee machine EMC compliance. In
some applications, it may be necessary for the machine
CAUTION
builder to incorporate more EMC mitigation techniques
than Kollmorgen had to use in the EMC test setups.
General Suggestions to Improve Machine EMC Performance
Use Kollmorgen cables – Kollmorgen cables have been designed with EMC considerations in
mind. Because subtle differences in cable construction can cause dramatic changes in EMC
performance use of Kollmorgen's motor power and feedback cables is recommended.
When joining or splicing sections of cable, be sure to maintain the integrity of the cable shield
along the entire length of the finished cable.
Separate cables according to type - AC Mains input, motor power and signal cables should be
separated from each other by at least 100 mm (4 in) to avoid cross coupling between them. If
cables of different types have to cross, they should do so at a 90° angle.
Route wiring close to machine frame - It is a good practice to run wires along the machine
frame (local ground) whenever practical, this couples some high frequency noise/signals that
could otherwise be troublesome directly to the local ground.
63
Never power the servo drive with the cover removed or with anything attached to
circuitry inside the cover.
If the drive must be removed from the cabinet, wait at least five
minutes after turning off power before removing any cables from
the drive or removing the drive from the mounting panel.
Never connect or disconnect any wiring to the drive while power is applied. Always
power down and wait five minutes before connecting or disconnecting any wires to the
terminals.
Never plug or unplug connectors with power applied.
Never connect or disconnect any wires to terminals with power applied.
If the drive indicates a fault condition, find the cause of the fault and fix it prior to
resetting the fault or power-cycling the drive.
OMPLIANCE WITH
4/13/2012
EN61800-3
Kollmorgen
S200 Position Node Installation Guide
Advertisement
Table of Contents
