Table of Contents
Advertisement
Connector Pinout And Descriptions
7.6 J2 – M
OTOR
Applicable Models: All except S21260-xNS (See TB1, above for this model).
1
Pin
J2-1
J2-2
J2-3
J2-4
Please refer to the product specifications section for appropriate wire sizing information.
Mating Connector Information
Screw Terminal Connector: 12 – 24 AWG Wire Range, Phoenix MSTB2,5/4-STF-5,08-BK
OR
Spring Cage Clamp Connector: 12 – 24 AWG Wire Range, Phoenix FKC 2,5/4-SFT-5,08-
BK
OR
Crimp Connector
Crimp Shell: 14-20 AWG Wire Range, Phoenix MSTBC 2,5/4-STZF-5,08-BK
Crimp Contact: 14-16 AWG Wire Range, Phoenix MSTBC-MT 1,5-2,5
Crimp Contact: 18-20 AWG Wire Range, Phoenix MSTBC-MT 0,5-1,0
7.7 J3 – SFD F
J3 is a 6-pin plugable IEEE 1394 style connector for the feedback device. Although this connector
mechanically accepts standard IEEE 1394 cables, it is electrically not an IEEE 1394 interface. The base
drive accepts either SFD (Smart Feedback Device) or Hall inputs.
Mating Connector Information
IEEE1394, Firewire type, 2.0 mm plug set
22 AWG Max., Molex 55100-0600
Refer to www.molex.com for assembly instructions.
34
P
C
OWER
ONNECTOR
(J2 Connector view from front of drive).
4
PE (Chassis Ground) on S200 AC Input Drives
BUS/CTRL GND on S200 DC Input Drives
Intended for motor ground and motor cable shield connection.
Motor Phase W Output
Motor Phase V Output
Motor Phase U Output
Refer to www.phoenixcon.com
C
EEDBACK
ONNECTOR
1
2
3
4
5
6
(J3 Connector view from front of drive)
4/13/2012
Description
Pins
Description
J3-1
+5 V Supply (200 mA) from drive
J3-2
+5 RTN 5V common
J3-3
SFD Communications -
J3-4
SFD Communications +
J3-5
NC
J3-6
NC
Shell
Shield Connection
Kollmorgen
S200 Position Node Installation Guide
Advertisement
Table of Contents
