Table of Contents
Advertisement
Connector Pinout And Descriptions
7.5 J1 – DC I
NPUT
The S200 DC input drives should be powered from power supplies with reinforced isolation.
On DC input drives, J1 is a 3 pin plugable connector.
Pin
J1-1
J1-2
J1-3
Please refer to the Specifications section for fusing and rating information.
To avoid damage to the connector and drive, NEVER plug or unplug J1 with
power applied.
CAUTION
Refer to the DC Power Supply Requirements section for detailed
requirements selecting a compatible power supply.
NOTE
Mating Connector Information
Screw Terminal Connector
12 – 24 AWG Wire Range, Phoenix MSTB2,5/3-STF-5,08-BK
OR Spring Cage Clamp Connector
12 – 24 AWG Wire Range, Phoenix FKC 2,5/3-SFT-5,08-BK
OR Crimp Connector
Crimp Shell: 14-20 AWG Wire Range, Phoenix MSTBC 2,5/3-STZF-5,08-BK
Crimp Contact: 14-16 AWG Wire Range, Phoenix MSTBC-MT 1,5-2,5
Crimp Contact: 18-20 AWG Wire Range, Phoenix MSTBC-MT 0,5-1,0
33
P
M
OWER
ODELS
(J1 Connector view from front of drive).
J1: DC Units Control Power
+ CNTL (Logic Input Power 10-90Vdc less than 8 watts)
BUS / CNTL GND (Logic and Bus Return)
+ DC BUS Input Power (20 to 90Vdcc)
Refer to www.phoenixcon.com.
4/13/2012
D
P
RIVE
3
1
Description
C
OWER
ONNECTOR
S200 Position Node Installation Guide
Kollmorgen
Advertisement
Table of Contents
