Fan Wiring - Factory Five Racing Gen 3 Type 65 Coupe Owner's Manual

Attach the second #14 screw.

Fan Wiring


Wire crimp tool

Fan mounting components, dash electrical components

There are a few ways to run the electric fan. The kit includes a relay, wiring, and a thermostat switch to
get used with the relay to turn the fan on and off at 185°F. The alternative way is to use the relay with a
dash mounted on/off switch or have the engine controls turn the fan on/off.
Dash mounted on/off switch

Using this set-up, the driver must watch the water temperature gauge and manually turn the fan on when
the water temperature gets to 212°F. The fan should only be needed while going less than 35mph or in
traffic.

This set-up will only power the fan with the ignition on. If you desire the fan to run with the key out
which could drain your battery, power the fan directly from the battery or from an always hot fuse in the
fuse panel.
Ground the black electric fan wire to the frame.
Connect the other electric fan wire to the #87 tab on the fan relay.
Ground the #85 tab to one of the 2-position dash toggle switches. The toggle will serve as your on-off switch.
Ground the other side of the dash switch to the frame.
Connect the #86 and #30 tabs to a +12V 30A fuse in the fuse panel.
30 – +12V
85 – Ground
86 –+12V
87 – Fan
Thermostat switch

Using this set-up, the fan will turn itself on and off when needed. If desired, an override switch can be
installed as well to manually turn the fan on if desired.

This set-up will only power the fan with the ignition on. If you desire the fan to run with the key out
which could drain your battery, power the fan directly from the battery or from an always hot fuse in the
fuse panel.
86
87
30
85
289
www.factoryfive.com 508-291-3443