975-0239-01-01
Figure 5-4 Connecting the Network Cables
6. Place the unit into the mounting plate and secure it with four #6 screws.
Figure 5-5 Securing the XW System Control Panel
7. Peel off the protective plastic coating covering the screen and indicator light.
To flush mount the XW System Control Panel with no mounting plate:
1. Peel the backing from the supplied mounting template sticker and place it in your
chosen installation location. Use the template to mark the location for the area to be
cut out.
2. Pilot-drill the mounting holes (if necessary, depending on your mounting surface) and,
using a jigsaw, cut out the hole in which the XW System Control Panel will be
inserted.
3. Route the network cable(s) from other Xanbus-enabled devices inside the wall and
through the opening.
This manual for use by qualified personnel only
The XW System Control Panel
5–5