XW Solar Charge Controller Installation
Wiring
DC Terminal Connector Locations
4–10
Figure 4-7 PV Negative Ground Jumper Location
Important:
Installations must meet all local electrical codes. Installations of this equipment
should only be performed by a qualified electrician or a Certified Renewable Energy (RE) System
Installer.
WARNING: Shock Hazard
Disconnect battery and PV sources before wiring.
Terminal connectors for DC wiring are located inside the wiring compartment. The labels
above the DC wiring terminals and inside the wiring compartment identify all the
connection points. See Figure 4-8.
-
-
Figure 4-8 DC Connection Terminals
This manual for use by qualified personnel only
- +
+
Enabled
Disabled
975-0239-01-01