Installing The Xw Automatic Generator Start; Figure 5-8 Xw Automatic Generator Start External Connections - Xantrex XW4024-120/240-60 Installation Manual

XW System Accessories Installation

Installing the XW Automatic Generator Start

Installation
Overview
5–10
Network ports
Network cables to other
Xanbus-enabled devices

Figure 5-8 XW Automatic Generator Start External Connections

Installing the XW Automatic Generator Start involves the following steps:
1. Mounting the unit.
2. Connecting the wiring harness to:
• the generator (page 5–13)
• thermostats (optional) (page 5–14)
• external shutdown switch (optional) (page 5–14)
• external ON/OFF switch and LED (optional) (page 5–15)
3. Connecting the wiring harness to the 20-contact connector on the XW Automatic
Generator Start.
4. Connecting the XW Automatic Generator Start to the XW System Control Panel and
other network-enabled devices (page 5–17).
Important:
Because each installation varies according to the location, the type of generator,
and the overall complexity of the Xanbus system, these instructions can offer only general
guidelines for the many installation options available.
WARNING: Shock Hazard
Before installing the XW Automatic Generator Start as part of a pre-existing Xanbus system, put
the system in Standby in order to disable the electrical operation of networked devices. See the
Automatic Generator Start Owner's Guide for instructions on putting the System in Standby.
This manual for use by qualified personnel only
20-contact
connector
Wiring harness (connection
to generator, thermostats,
and external switches)
975-0239-01-01