XW Solar Charge Controller Installation
4. Press Enter.
The settings are automatically copied from the selected unit.
:
Note
The Copy From command will not give you any indication that it has completed
its task. However, you can quickly check for yourself that the charger settings you have
chosen have been copied properly by viewing some of the settings you originally
configured.
5. Uncover the PV array and/or apply power with the disconnect or selector switch.
The XW SCC starts up in sleep mode and waits for a short period to determine that the
input voltage is greater than the output voltage. After the input voltage exceeds the output
voltage by the required margin for 10 seconds, the unit begins operating.
4–18
975-0239-01-01
This manual for use by qualified personnel only