Figure 5-2 Inserting The Mounting Plate; Figure 5-3 Securing The Mounting Plate - Xantrex XW4024-120/240-60 Installation Manual

XW System Accessories Installation
5–4
3. Insert the mounting plate with the two tabs in a vertical position into the hole (see
Figure 5-2).

Figure 5-2 Inserting the Mounting Plate

4. Secure the mounting plate by tightening the two screws to rotate the tabs to the
horizontal position (see Figure 5-3) and pull the tabs tight against the inner surface of
the wall. Be careful not to overtighten the screws and damage the wall.
Rotate tabs to
horizontal position

Figure 5-3 Securing the Mounting Plate

5. Connect the network cable(s) (and terminator if necessary) to either input on the back
of the XW System Control Panel. See Figure 5-4.
Connect a network terminator to the XW System Control Panel if it is the last device
at the end of a series-type network layout.
Important:
To ensure communication signal quality, the network must be terminated at each
end with a terminator.
This manual for use by qualified personnel only
Tabs in vertical position
975-0239-01-01