System Components And Accessories; Xw Inverter/Charger; Xw Conduit Box; Figure 1-2 Xw Inverter/Charger - Xantrex XW4024-120/240-60 Installation Manual

System Components and Accessories

XW Inverter/Charger

XW Conduit Box

975-0239-01-01
The XW Inverter/Charger is a modular "building block" sine-wave inverter/charger that
can be used for both residential and commercial stand-alone, grid-backup, and grid-tie
applications with battery energy storage. The XW Series is a self-contained DC to AC
inverter, battery charger, and AC transfer switch. Up to three inverters can be installed in
parallel to create larger 120-240-volt, 3-wire, single-phase systems allowing for increased
capacity.

Figure 1-2 XW Inverter/Charger

A Battery Temperature Sensor (FGA # 808-0232-02) is also included with the XW
Inverter/Charger. The Battery Temperature Sensor monitors the temperature of the battery
bank and adjusts the charging accordingly. See page 2–13 for installation instructions for
this accessory.
A conduit box (FGA # 865-1025) is available to enclose the bottom of the XW
Inverter/Charger and protect the cabling. Use of the conduit box may be required
depending on the local electrical code. Be sure to consult with the local electrical
authority to ensure the installation is code-compliant.

Figure 1-3 XW Conduit Box

The XW Conduit Box comes in two pieces and mounts directly to the bottom of the
inverter/charger with keyhole slots and screws. It is secured to the inverter by two
#10-32 screws and is secured to the wall by two screws (not provided).
This manual for use by qualified personnel only
System Components and Accessories
Includes:
• Mounting Panel
• DC terminal Covers
• Network Terminator
• Battery Temperature Sensor
• Air Filter
• Mounting Hardware
• AUX Port Connector
1–3