Explosive Gas Precautions - Xantrex XW4024-120/240-60 Installation Manual

Important Safety Instructions
Limitations on Use
Single-phase Operation Only

Explosive Gas Precautions

FCC Information to the User
vi
WARNING: Limitations on Use
The XW Power System is not intended for use in connection with life support
systems or other medical equipment or devices.
CAUTION
The XW4024-120/240-60, XW4548-120/240-60 and XW6048-120/240-60 series of
Inverter/Chargers are designed and tested for operation with single phase, three wire
(120V/240V) AC sources and should not be connected to a three phase AC source.
Connecting the device to a three phase source may result in damage to the unit and any
loads connected to the Inverter/Charger.
1. Working in the vicinity of lead acid batteries is dangerous. Batteries generate
explosive gases during normal operation. Therefore, you must read this guide and
follow the instructions exactly before installing or using your inverter/charger.
2. To reduce the risk of battery explosion, follow these instructions and those published
by the battery manufacturer and the manufacturer of the equipment in which the
battery is installed.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
975-0239-01-01