Services; Sip-Based Media Recording Parameters - AudioCodes Mediant 800B User Manual

Parameter
Enable Pattern Detector
[EnablePatternDetector]
[PDPattern]
[PDThreshold]

72.14 Services

72.14.1 SIP-based Media Recording Parameters

The SIP-based media recording parameters are described in the table below.
Table 72-76: SIP-based Media Recording Parameters
Parameter
SIP Recording Application
configure voip > sip-definition
sip-recording settings >
enable-sip-rec
[EnableSIPRec]
Recording Server (SRS)
Destination Username
configure voip > sip-definition
sip-recording settings >
siprec-server-dest-username
[SIPRecServerDestUsername]
SIP Recording Rules Table
User's Manual
Enables the Pattern Detector (PD) feature.

[0] Disable (default)

[1] Enable
Defines the patterns that can be detected by the Pattern
Detector.
The valid range is 0 to 0xFF.
Note: For the parameter to take effect, a device reset is
required.
Defines the number of consecutive patterns to trigger the
pattern detection event.
The valid range is 0 to 31. The default is 5.
Note: For the parameter to take effect, a device reset is
required.
Enables the SIP-based Media Recording feature:

[0] Disable (default)

[1] Enable
Note: For the parameter to take effect, a device reset is required.
Defines the SIP user part for the recording server. This user part is
added in the SIP To header of the INVITE message that the device
sends to the recording server.
The valid value is a string of up to 50 characters. By default, no user
part is defined.
1320
Mediant 800B Gateway & E-SBC
Description
Description
Document #: LTRT-10632