AudioCodes Mediant 800B User Manual page 1288

Parameter
Set Tel-to-IP Redirect Reason
configure voip > gateway
manipulation settings > tel2ip-
redir-reason
[SetTel2IpRedirectReason]
Send Screening Indicator to IP
[ScreeningInd2IP]
Send Screening Indicator to
ISDN
[ScreeningInd2ISDN]
Copy Destination Number to
Redirect Number
cp-dst-nb-2-redir-nb
[CopyDest2RedirectNumber]
User's Manual
Note: The parameter is applicable only to digital interfaces.
Defines the redirect reason for Tel-to-IP calls. If redirect (diversion)
information is received from the Tel, the redirect reason is set to the
value of the parameter before the device sends it on to the IP.

[-1] Not Configured (default)

[0] Unkown

[1] Busy

[2] No Reply

[3] Network Busy

[4] Deflection

[9] DTE out of Order

[10] Forwarding DTE

[13] Transfer

[14] PickUp

[15] Systematic/Unconditional
Note: The parameter is applicable only to digital interfaces.
Overrides the calling party's number (CPN) screening indication in
the received ISDN SETUP message for Tel-to-IP calls.

[-1] Not Configured = (Default) Not configured (interworking from
ISDN to IP) or set to 0 for CAS.

[0] User Provided = CPN set by user, but not screened (verified).

[1] User Passed = CPN set by user, verified and passed.

[2] User Failed = CPN set by user, and verification failed.

[3] Network Provided = CPN set by network.
Note:

The parameter is applicable only if the Remote Party ID (RPID)
header is enabled.

The parameter is applicable only to digital interfaces.
Overrides the screening indicator of the calling party's number for
IP-to-Tel ISDN calls.

[-1] Not Configured = (Default) Not configured (interworking from
IP to ISDN).

[0] User Provided = user provided, not screened.

[1] User Passed = user provided, verified and passed.

[2] User Failed = user provided, verified and failed.

[3] Network Provided = network provided
Note: The parameter is applicable only to digital interfaces.
Enables the device to copy the received ISDN (digital interfaces)
called number to the outgoing SIP Diversion header for Tel-to-IP
calls (even if a Redirecting Number IE is not received in the ISDN
Setup message, for digital interfaces). Therefore, the called number
is used as a redirect number. Call redirection information is typically
used for Unified Messaging and voice mail services to identify the
recipient of a message.

[0] Don't copy = (Default) Disable.

[1] Copy after phone number manipulation = Copies the called
number after manipulation. The device first performs Tel-to-IP
destination phone number manipulation (i.e., on the SIP To
1288
Mediant 800B Gateway & E-SBC
Description
Document #: LTRT-10632