Configuring Microsoft Internet Explorer Client Parameters - Cisco FirePOWER ASA 5500 series Configuration Manual

Group Policies

Configuring Microsoft Internet Explorer Client Parameters

The following commands configure the proxy server parameters for a Microsoft Internet Explorer client.
Configure a Microsoft Internet Explorer browser proxy server and port for a client PC by entering the
Step 1
msie-proxy server command in group-policy configuration mode:
hostname(config-group-policy)# msie-proxy server {value server[:port] | none}
hostname(config-group-policy)#
The default value is none. To remove the attribute from the configuration, use the no form of the
command.
hostname(config-group-policy)# no msie-proxy server
hostname(config-group-policy)#
The line containing the proxy server IP address or hostname and the port number must be less than 100
characters long.
The following example shows how to configure the IP address 192.168.10.1 as a Microsoft Internet
Explorer proxy server, using port 880, for the group policy named FirstGroup:
hostname(config)# group-policy FirstGroup attributes
hostname(config-group-policy)# msie-proxy server value 192.168.21.1:880
hostname(config-group-policy)#
Configure the Microsoft Internet Explorer browser proxy actions ("methods") for a client PC by entering
Step 2
the msie-proxy method command in group-policy configuration mode.
hostname(config-group-policy)# msie-proxy method [auto-detect | no-modify | no-proxy |
use-server]
hostname(config-group-policy)#
The default value is use-server. To remove the attribute from the configuration, use the no form of the
command.
hostname(config-group-policy)# no msie-proxy method
use-server
hostname(config-group-policy)#
The available methods are as follows:
•
•
•
•
The line containing the proxy server IP address or hostname and the port number must be less than 100
characters long.
The following example shows how to configure auto-detect as the Microsoft Internet Explorer proxy
setting for the group policy named FirstGroup:
hostname(config)# group-policy FirstGroup attributes
hostname(config-group-policy)# msie-proxy method auto-detect
hostname(config-group-policy)#
Cisco Security Appliance Command Line Configuration Guide
30-48
]
auto-detect—Enables the use of automatic proxy server detection in Internet Explorer for the client
PC.
no-modify—Leaves the HTTP browser proxy server setting in Internet Explorer unchanged for this
client PC.
no-proxy—Disables the HTTP proxy setting in Internet Explorer for the client PC.
use-server—Sets the HTTP proxy server setting in Internet Explorer to use the value configured in
the msie-proxy server command.
Chapter 30 Configuring Tunnel Groups, Group Policies, and Users
[
auto-detect
| | |
no-modify no-proxy
OL-10088-01