Cisco FirePOWER ASA 5500 series Configuration Manual page 229

Chapter 14 Configuring Failover
Note
hostname/context(config-if)# ip address active_addr netmask standby standby_addr
In routed firewall mode and for the management-only interface, this command is entered in interface
configuration mode for each interface. In transparent firewall mode, the command is entered in global
configuration mode.
Step 4 (Optional) To enable Stateful Failover, configure the Stateful Failover link.
Specify the interface to be used as Stateful Failover link:
a.
hostname(config)# failover link if_name phy_if
The if_name argument assigns a logical name to the interface specified by the phy_if argument. The
phy_if argument can be the physical port name, such as Ethernet1, or a previously created
subinterface, such as Ethernet0/2.3. This interface should not be used for any other purpose (except,
optionally, the failover link).
b. Assign an active and standby IP address to the Stateful Failover link:
hostname(config)# failover interface ip if_name ip_addr mask standby ip_addr
The standby IP address must be in the same subnet as the active IP address. You do not need to
identify the standby IP address subnet mask.
The Stateful Failover link IP address and MAC address do not change at failover except for when
Stateful Failover uses a regular data interface. The active IP address always stays with the primary
unit, while the standby IP address stays with the secondary unit.
Enable the interface:
c.
hostname(config)# interface phy_if
hostname(config-if)# no shutdown
Step 5 Configure the failover groups. You can have at most two failover groups. The failover group command
creates the specified failover group if it does not exist and enters the failover group configuration mode.
For each failover group, you need to specify whether the failover group has primary or secondary
preference using the primary or secondary command. You can assign the same preference to both
failover groups. For load balancing configurations, you should assign each failover group a different unit
preference.
The following example assigns failover group 1 a primary preference and failover group 2 a secondary
preference:
hostname(config)# failover group 1
hostname(config-fover-group)# primary
hostname(config-fover-group)# exit
hostname(config)# failover group 2
hostname(config-fover-group)# secondary
hostname(config-fover-group)# exit
Assign each user context to a failover group using the join-failover-group command in context
Step 6
configuration mode.
Any unassigned contexts are automatically assigned to failover group 1. The admin context is always a
member of failover group 1.
Enter the following commands to assign each context to a failover group:
OL-10088-01
Do not configure an IP address for the Stateful Failover link if you are going to use a dedicated
Stateful Failover interface. You use the failover interface ip command to configure a dedicated
Stateful Failover interface in a later step.
Cisco Security Appliance Command Line Configuration Guide
Configuring Failover
14-27