Cisco FirePOWER ASA 5500 series Configuration Manual page 776

Configuring AAA for System Administrators
Local Command Authorization Prerequisites
Complete the following tasks as part of your command authorization configuration:
•
•
Default Command Privilege Levels
By default, the following commands are assigned to privilege level 0. All other commands are at
level 15.
•
•
•
•
•
•
•
•
•
•
•
•
If you move any configure mode commands to a lower level than 15, be sure to move the configure
command to that level as well, otherwise, the user will not be able to enter configuration mode.
To view all privilege levels, see the
Assigning Privilege Levels to Commands and Enabling Authorization
To assign a command to a new privilege level, and enable authorization, follow these steps:
Step 1 To assign a command to a privilege level, enter the following command:
hostname(config)# privilege [show | clear | cmd] level level [mode {enable | cmd}] command
command
Repeat this command for each command you want to reassign.
See the following information about the options in this command:
Cisco Security Appliance Command Line Configuration Guide
40-8
Configure enable authentication. (See the
Mode" section on page 40-5.)
Alternatively, you can use the login command (which is the same as the enable command with
authentication), which requires no configuration. We do not recommend this option because it is not
as secure as enable authentication.
You can also use CLI authentication, but it is not required.
Configure each user in the local database at a privilege level from 0 to 15.
show checksum
show curpriv
enable (enable mode)
help
show history
login
logout
pager
show pager
clear pager
quit
show version
"Configuring Authentication To Access Privileged EXEC
"Viewing Command Privilege Levels" section on page
Chapter 40 Managing System Access
40-10.
OL-10088-01