Clearing The Configuration - Cisco FirePOWER ASA 5500 series Configuration Manual

Chapter 35 Configuring the PPPoE Client
Local Internet Address 199.99.99.3
6 packets sent, 6 received, 84 bytes sent, 0 received
hostname#

Clearing the Configuration

To remove all vpdn group commands from the configuration, use the clear configure vpdn group
command in global configuration mode:
hostname(config)# clear configure vpdn group
To remove all vpdn username commands, use the clear configure vpdn username command:
hostname(config)# clear configure vpdn username
Entering either of these commands has no affect upon active PPPoE connections.
Using Related Commands
Use the following command to cause the DHCP server to use the WINS and DNS addresses provided by
the access concentrator as part of the PPP/IPCP negotiations:
hostname(config)# dhcpd auto_config [client_ifx_name]
This command is only required if the service provider provides this information as described in
RFC 1877. The client_ifx_name parameter identifies the interface supported by the DHCP auto_config
option. At this time, this keyword is not required because the PPPoE client is only supported on a single
outside interface.
OL-10088-01
Cisco Security Appliance Command Line Configuration Guide
Clearing the Configuration
35-5