Configuring VPN
Configuring an IPSec VPN Tunnel for Remote Access with a VPN Client
Configuring an IPSec VPN Tunnel for Remote Access with a
VPN Client
NOTE
NOTE
Cisco SA 500 Series Security Appliances Administration Guide
The VPN Wizard helps you to set up an IPSec VPN tunnel to allow workers to
connect to your network from remote locations, using an IPSec VPN client. The
Wizard sets most parameters to defaults as proposed by the VPN Consortium
(VPNC), and assumes a pre-shared key, which greatly simplifies setup. After
creating the policies through the VPN Wizard, you can update any of the
parameters by using the other options in the navigation tree.
With the Wizard's default settings, you will need to add VPN users through the
IPSec VPN users page after you complete the Wizard. Alternatively, you can edit
the IKE policy to allow Extended Authentication (XAUTH) from user records stored
on an external authentication server such as a RADIUS server.
For information about the VPNC recommendations, visit the following website:
www.vpnc.org/vpn-standards.html
Figure 11 IPSec VPN Remote Access with a VPN Client
DNS Server
10.10.10.163
Internal
Inside
network
10.10.10.0
WINS Server
10.10.10.133
For information about the VPNC recommendations, visit the following website:
www.vpnc.org/vpn-standards.html
Security
Appliance
Outside
Internet
8
Personal Computer
Using VPN Software Client
Personal Computer
Using VPN Software Client
Personal Computer
Using VPN Software Client
153