Cisco FirePOWER ASA 5500 series Configuration Manual page 244

Configuring Failover
Group 1
Group 2
Stateful Failover Logical Update Statistics
The following is sample output from the show failover group command for Active/Active Failover. The
information displayed is similar to that of the show failover command, but limited to the specified
group.
hostname# show failover group 1
Last Failover at: 04:09:59 UTC Jan 4 2005
This host:
Other host:
Stateful Failover Logical Update Statistics
Cisco Security Appliance Command Line Configuration Guide
14-42
State:
Active time:
State:
Active time:
slot 0: ASA-5530 hw/sw rev (1.0/7.0(0)79) status (Up Sys)
slot 1: SSM-IDS-20 hw/sw rev (1.0/5.0(0.1)S91(0.1)) status (Up)
admin Interface outside (10.132.8.6): Normal
admin Interface third (10.132.9.6): Normal
admin Interface inside (10.130.8.6): Normal
admin Interface fourth (10.130.9.6): Normal
ctx1 Interface outside (10.1.1.2): Normal
ctx1 Interface inside (10.2.2.2): Normal
ctx2 Interface outside (10.3.3.1): Normal
ctx2 Interface inside (10.4.4.1): Normal
Link : third GigabitEthernet0/2 (up)
Stateful Obj xmit
General 1973
sys cmd 380
up time 0
RPC services 0
TCP conn 1435
UDP conn 0
ARP tbl 124
Xlate_Timeout 0
VPN IKE upd 15
VPN IPSEC upd 90
VPN CTCP upd 0
VPN SDI upd 0
VPN DHCP upd 0
Logical Update Queue Information
Cur
Recv Q: 0
Xmit Q: 0
Table 14-8 provides descriptions for the information shown.
Secondary
State:
Active time:
admin Interface outside (192.168.5.121): Normal
admin Interface inside (192.168.0.1): Normal
Primary
State:
Active time:
admin Interface outside (192.168.5.131): Normal
admin Interface inside (192.168.0.11): Normal
Status: Configured.
Standby Ready
190 (sec)
Active
3322 (sec)
xerr rcv
0 1895
0 380
0 0
0 0
0 1450
0 0
0 65
0 0
0 0
0 0
0 0
0 0
0 0
Max Total
1 1895
0 1940
Active
186 (sec)
Standby
0 (sec)
Chapter 14 Configuring Failover
rerr
0
0
0
0
0
0
0
0
0
0
0
0
0
OL-10088-01