Configuring The Ssl Vpn Client - Cisco Small Business RV220W Administration Manual

Configuring Virtual Private Networks and Security
Configuring VPNs
STEP 1
STEP 2
NOTE
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
Cisco RV220W Administration Guide

Configuring the SSL VPN Client

An SSL VPN tunnel client provides a point-to-point connection between the
browser-side machine and the RV220W. When an SSL VPN connection is
launched from the user portal, a virtual network adapter with an IP address and
DNS and WINS settings is automatically created on the client host, which allows
local applications to talk to services on the private network without any special
network configuration on the remote SSL VPN client machine.
To configure the SSL VPN client:
Choose VPN > SSL VPN Client > SSL VPN Client.
To enable split tunnel support, check the Enable box. If the box is not checked, full
tunnel support is enabled. With full tunnel support, all traffic from the VPN client
goes through the VPN tunnel. Client routes are not required. For a split tunnel, only
traffic that is specified by client routes goes through the VPN tunnel.
If split tunnel support is enabled, be sure to configure SSL VPN client routes if the
client address range is in a different subnet than the corporate network, or if your
network has multiple subnets. See
configure a client-IP address range that does not directly overlap with any of the
addresses on your local network.
(Optional) Enter the DNS suffix, or the name which will be given to the SSL VPN
client.
(Optional) Enter the primary DNS server, or the DNS server IP address to set on the
network adaptor created on the client host.
(Optional) Enter the secondary DNS server, or the secondary DNS server IP
address to set on the network adaptor created on the client host.
Enter values in the Client Address Range Begin and Client Address Range End
fields. Clients who connect to the tunnel get a DHCP served IP address assigned
to the network adaptor from the range of addresses beginning and ending with
these IP addresses.
Enter the LCP Timeout value. The LCP timeout value is three times the number
entered and is the time, in seconds, for the LCP echo interval used by the SSL VPN
tunnel connections. The updated value is effective only for new connections and
existing SSL VPN tunnel connections must be restarted for the new value to apply.
Click Save.
Configuring Client Routes, page
5
126. Also,
125