Configuring Ospf - Cisco FirePOWER ASA 5500 series Configuration Manual

Chapter 9 Configuring IP Routing
If a route matches the match commands, then the following set commands determine the action to
perform on the route before redistributing it.
•
•
The following example shows how to redistribute routes with a hop count equal to 1 into OSPF. The
security appliance redistributes these routes as external LSAs with a metric of 5, metric type of Type 1,
and a tag equal to 1.
hostname(config)# route-map 1-to-2 permit
hostname(config-route-map)# match metric 1
hostname(config-route-map)# set metric 5
hostname(config-route-map)# set metric-type type-1

Configuring OSPF

This section describes how to configure OSPF. This section includes the following topics:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
OL-10088-01
To set the metric, enter the following command:
hostname(config-route-map)# set metric metric_value
The metric_value can be a value between 0 and 294967295
To set the metric type, enter the following command:
hostname(config-route-map)# set metric-type {type-1 | type-2}
OSPF Overview, page 9-8
Enabling OSPF, page 9-8
Redistributing Routes Into OSPF, page 9-9
Configuring OSPF Interface Parameters, page 9-10
Configuring OSPF Area Parameters, page 9-12
Configuring OSPF NSSA, page 9-13
Defining Static OSPF Neighbors, page 9-15
Configuring Route Summarization Between OSPF Areas, page 9-14
Configuring Route Summarization When Redistributing Routes into OSPF, page 9-14
Generating a Default Route, page 9-16
Configuring Route Calculation Timers, page 9-16
Logging Neighbors Going Up or Down, page 9-17
Displaying OSPF Update Packet Pacing, page 9-17
Monitoring OSPF, page 9-18
Restarting the OSPF Process, page 9-18
Cisco Security Appliance Command Line Configuration Guide
Configuring OSPF
9-7