Managing The Aip Ssm - Cisco FirePOWER ASA 5500 series Configuration Manual

Managing AIP SSM and CSC SSM
The Cisco ASA 5500 series adaptive security appliance supports a variety of SSMs. This chapter
describes how to configure the adaptive security appliance to support an AIP SSM or a CSC SSM,
including how to send traffic to these SSMs.
For information about the 4GE SSM for the ASA 5000 series adaptive security appliance, see
"Configuring Ethernet Settings and
The Cisco PIX 500 series security appliances cannot support SSMs.
Note
This chapter includes the following sections:
•
•
•
•

Managing the AIP SSM

This section contains the following topics:
•
•
•
•
About the AIP SSM
The ASA 5500 series adaptive security appliance supports the AIP SSM, which runs advanced
IPS software that provides further security inspection. The adaptive security appliance diverts packets
to the AIP SSM just before the packet exits the egress interface (or before VPN encryption occurs, if
configured) and after other firewall policies are applied. For example, packets that are blocked by an
access list are not forwarded to the AIP SSM.
OL-10088-01
Managing the AIP SSM, page 22-1
Managing the CSC SSM, page 22-5
Checking SSM Status, page 22-13
Transferring an Image onto an SSM, page 22-14
About the AIP SSM, page 22-1
Getting Started with the AIP SSM, page 22-2
Diverting Traffic to the AIP SSM, page 22-2
Sessioning to the AIP SSM and Running Setup, page 22-4
C H A P T E R
Subinterfaces".
Cisco Security Appliance Command Line Configuration Guide
22
Chapter 5,
22-1