Cisco FirePOWER ASA 5500 series Configuration Manual page 96

Configuring Resource Management
Table 6-1 Resource Names and Limits
Rate or
Resource Name Concurrent
mac-addresses Concurrent
conns Concurrent
or Rate
inspects Rate
hosts Concurrent
asdm Concurrent
ssh Concurrent
syslogs Rate
telnet Concurrent
xlates Concurrent
1. If this column value is N/A, then you cannot set a percentage of the resource because there is no hard system limit for the resource.
For example, to set the default class limit for conns to 10 percent instead of unlimited, enter the
following commands:
hostname(config)# class default
hostname(config-class)# limit-resource conns 10%
All other resources remain at unlimited.
To add a class called gold, enter the following commands:
hostname(config)# class gold
Cisco Security Appliance Command Line Configuration Guide
6-6
Minimum and
Maximum Number
per Context System Limit
N/A 65,535
N/A Concurrent connections:
See the
Platforms and Feature
Licenses" section on
page A-1
connection limit for your
platform.
Rate: N/A
N/A N/A
N/A N/A
1 minimum 32
5 maximum
1 minimum 100
5 maximum
N/A N/A
1 minimum 100
5 maximum
N/A N/A
Chapter 6
1
Description
For transparent firewall mode, the number of
MAC addresses allowed in the MAC address
table.
TCP or UDP connections between any two
"Supported hosts, including connections between one
host and multiple other hosts.
for the
Application inspections.
Hosts that can connect through the security
appliance.
ASDM management sessions.
Note
SSH sessions.
System log messages.
Telnet sessions.
Address translations.
Adding and Managing Security Contexts
ASDM sessions use two HTTPS
connections: one for monitoring that
is always present, and one for making
configuration changes that is present
only when you make changes. For
example, the system limit of 32
ASDM sessions represents a limit of
64 HTTPS sessions.
OL-10088-01