Cisco FirePOWER ASA 5500 series Configuration Manual page 488

Skinny (SCCP) Inspection
Where the policy_map_name is the name of the policy map. The CLI enters policy-map configuration
mode.
(Optional) To add a description to the policy map, enter the following command:
Step 4
hostname(config-pmap)# description string
To apply actions to matching traffic, perform the following steps.
Step 5
Specify the traffic on which you want to perform actions using one of the following methods:
a.
Specify the action you want to perform on the matching traffic by entering the following command:
b.
hostname(config-pmap-c)# {[drop [send-protocol-error] |
drop-connection [send-protocol-error]| mask | reset] [log] | rate-limit message_rate}
Not all options are available for each match or class command. See the CLI help or the Cisco
Security Appliance Command Reference for the exact options available.
The drop keyword drops all packets that match.
The send-protocol-error keyword sends a protocol error message.
The drop-connection keyword drops the packet and closes the connection.
The mask keyword masks out the matching portion of the packet.
The reset keyword drops the packet, closes the connection, and sends a TCP reset to the server
and/or client.
The log keyword, which you can use alone or with one of the other keywords, sends a system log
message.
The rate-limit message_rate argument limits the rate of messages.
You can specify multiple class or match commands in the policy map. For information about the order
Step 6
of class and match commands, see the
page
To enter parameters configuration mode, enter the following command:
a.
hostname(config-pmap)# parameters
hostname(config-pmap-p)#
To enforce registration before calls can be placed, enter the following command:
b.
hostname(config-pmap-p)# enforce-registration
To set the maximum SCCP station message ID allowed, enter the following command:
c.
hostname(config-pmap-p)# message-ID max hex_value
Where the hex_value argument is the station message ID in hex.
To check RTP packets flowing on the pinholes for protocol conformance, enter the following
d.
command:
hostname(config-pmap-p)# rtp-conformance [enforce-payloadtype]
Cisco Security Appliance Command Line Configuration Guide
25-70
Specify the SCCP class map that you created in
•
hostname(config-pmap)# class class_map_name
hostname(config-pmap-c)#
Specify traffic directly in the policy map using one of the match commands described in
•
If you use a match not command, then any traffic that does not match the criterion in the match
not command has the action applied.
21-10.To configure parameters that affect the inspection engine, perform the following steps:
Chapter 25 Configuring Application Layer Protocol Inspection
Step 3 by entering the following command:
"Defining Actions in an Inspection Policy Map" section on
Step 3.
OL-10088-01