Cisco FirePOWER ASA 5500 series Configuration Manual page 453

Chapter 25 Configuring Application Layer Protocol Inspection
hostname(config-network)# network-object host 192.168.50.100
hostname(config)# gtp-map gtp-policy
hostname(config-gtp-map)# permit response to-object-group sgsn32 from-object-group
gsnpool32
h. To specify the maximum number of GTP requests that will be queued waiting for a response, enter
the following command:
hostname(config-gtp-map)# request-queue max_requests
where the max_requests argument sets the maximum number of GTP requests that will be queued
waiting for a response, from 1 to 4294967295. The default is 200.
When the limit has been reached and a new request arrives, the request that has been in the queue
for the longest time is removed. The Error Indication, the Version Not Supported and the SGSN
Context Acknowledge messages are not considered as requests and do not enter the request queue
to wait for a response.
To change the inactivity timers for a GTP session, enter the following command:
i.
hostname(config-gtp-map)# timeout {gsn | pdp-context | request | signaling | tunnel}
hh:mm:ss
Enter this command separately for each timeout.
The gsn keyword specifies the period of inactivity after which a GSN will be removed.
The pdp-context keyword specifies the maximum period of time allowed before beginning to
receive the PDP context.
The request keyword specifies the maximum period of time allowed before beginning to receive the
GTP message.
The signaling keyword specifies the period of inactivity after which the GTP signaling will be
removed.
The tunnel keyword specifies the period of inactivity after which the GTP tunnel will be torn down.
The hh:mm:ss argument is the timeout where hh specifies the hour, mm specifies the minutes, and
ss specifies the seconds. The value 0 means never tear down.
To specify the maximum number of GTP tunnels allowed to be active on the security appliance,
j.
enter the following command:
hostname(config-gtp-map)# tunnel-limit max_tunnels
where the max_tunnels argument is the maximum number of tunnels allowed, from 1 to
4294967295. The default is 500.
New requests will be dropped once the number of tunnels specified by this command is reached.
The following example shows how to limit the number of tunnels in the network:
hostname(config)# policy-map type inspect gtp gmap
hostname(config-pmap)# parameters
hostname(config-pmap-p)# tunnel-limit 3000
hostname(config)# policy-map global_policy
hostname(config-pmap)# class inspection_default
hostname(config-pmap-c)# inspect gtp gmap
hostname(config)# service-policy global_policy global
OL-10088-01
Cisco Security Appliance Command Line Configuration Guide
GTP Inspection
25-35