Monitoring And Debugging The Pppoe Client - Cisco FirePOWER ASA 5500 series Configuration Manual

Monitoring and Debugging the PPPoE Client

This command causes the security appliance to use the specified address instead of negotiating with the
PPPoE server to assign an address dynamically. Replace ipaddress and mask with the IP address and
subnet mask assigned to your security appliance.
For example:
hostname(config-if)# ip address outside 201.n.n.n 255.255.255.0 pppoe
Note The setroute option is an option of the ip address command that you can use to allow the access
concentrator to set the default routes when the PPPoE client has not yet established a connection. When
using the setroute option, you cannot have a statically defined route in the configuration.
Monitoring and Debugging the PPPoE Client
Use the following command to display the current PPPoE client configuration information:
hostname# show ip address outside pppoe
Use the following command to enable or disable debugging for the PPPoE client:
hostname# [no] debug pppoe {event | error | packet}
The following summarizes the function of each keyword:
•
•
•
Use the following command to view the status of PPPoE sessions:
hostname# show vpdn session [l2tp | pppoe] [id sess_id | packets | state | window]
The following example shows a sample of information provided by this command:
hostname# show vpdn
Tunnel id 0, 1 active sessions
Remote Internet Address is 10.0.0.1
hostname#
hostname# show vpdn session
PPPoE Session Information (Total tunnels=1 sessions=1)
Remote Internet Address is 10.0.0.1
Session state is SESSION_UP
hostname#
hostname# show vpdn tunnel
PPPoE Tunnel Information (Total tunnels=1 sessions=1)
Tunnel id 0, 1 active sessions
time since change 65901 secs
Remote Internet Address 10.0.0.1
Cisco Security Appliance Command Line Configuration Guide
35-4
event—Displays protocol event information
error—Displays error messages
packet—Displays packet information
time since change 65862 secs
Remote Internet Address 10.0.0.1
Local Internet Address 199.99.99.3
6 packets sent, 6 received, 84 bytes sent, 0 received
Session state is SESSION_UP
Time since event change 65865 secs, interface outside
PPP interface id is 1
6 packets sent, 6 received, 84 bytes sent, 0 received
Time since event change 65887 secs, interface outside
PPP interface id is 1
6 packets sent, 6 received, 84 bytes sent, 0 received
Chapter 35 Configuring the PPPoE Client
OL-10088-01