Cisco FirePOWER ASA 5500 series Configuration Manual page 272

Chapter 16 Identifying Traffic with Access Lists
Access List Overview
If you want to allow an outside host to access an inside host, you can apply an inbound access list on the
outside interface. You need to specify the translated address of the inside host in the access list because
that address is the address that can be used on the outside network (see Figure 16-2).
Figure 16-2 IP Addresses in Access Lists: NAT used for Destination Addresses
209.165.200.225
ACL
Permit from 209.165.200.225 to 209.165.201.5
Outside
Inside
10.1.1.34 209.165.201.5
Static NAT
See the following commands for this example:
hostname(config)# access-list OUTSIDE extended permit ip host 209.165.200.225 host
209.165.201.5
hostname(config)# access-group OUTSIDE in interface outside
Cisco Security Appliance Command Line Configuration Guide
16-4
OL-10088-01