Cisco FirePOWER ASA 5500 series Configuration Manual page 241

Chapter 14 Configuring Failover
Table 14-7
Field
Failover
Cable status:
Failover Unit
Failover LAN Interface
Unit Poll frequency
Interface Poll frequency
Interface Policy
Monitored Interfaces
failover replication http
Last Failover at:
This host:
Other host:
Primary or Secondary
Active time:
slot x
OL-10088-01
Show Failover Display Description
Options
On
•
Off
•
Normal—The cable is connected to both units, and they both have
•
power.
My side not connected—The serial cable is not connected to this
•
unit. It is unknown if the cable is connected to the other unit.
Other side is not connected—The serial cable is connected to this
•
unit, but not to the other unit.
Other side powered off—The other unit is turned off.
•
N/A—LAN-based failover is enabled.
•
Primary or Secondary.
Displays the logical and physical name of the failover link.
Displays the number of seconds between hello messages sent to the
peer unit and the number of seconds during which the unit must receive
a hello message on the failover link before declaring the peer failed.
n seconds
The number of seconds you set with the failover polltime interface
command. The default is 15 seconds.
Displays the number or percentage of interfaces that must fail to trigger
failover.
Displays the number of interfaces monitored out of the maximum
possible.
Displays if HTTP state replication is enabled for Stateful Failover.
The date and time of the last failover in the following form:
hh:mm:ss UTC DayName Month Day yyyy
UTC (Coordinated Universal Time) is equivalent to GMT (Greenwich
Mean Time).
For each host, the display shows the following information.
Active
•
Standby
•
n (sec)
The amount of time the unit has been active. This time is cumulative,
so the standby unit, if it was active in the past, also shows a value.
Information about the module in the slot or empty.
Cisco Security Appliance Command Line Configuration Guide
Configuring Failover
14-39