Example 12: Primary System Configuration - Cisco FirePOWER ASA 5500 series Configuration Manual
Security appliance command line
Hide thumbs
Also See for FirePOWER ASA 5500 series:
- Datasheet (20 pages) ,
- Configuration manual (1140 pages)
Table of Contents
Advertisement
Appendix B
Sample Configurations
Example 12: Primary System Configuration
You must first enable multiple context mode using the mode multiple command. The mode is not stored
in the configuration file, even though it endures reboots. Enter the show mode command to view the
current mode.
firewall transparent
hostname ciscopix
enable password farscape
password crichton
asdm image flash:/asdm.bin
boot system flash:/cdisk.bin
mac-address auto
interface Ethernet0
description LAN/STATE Failover Interface
interface Ethernet1
no shutdown
interface Ethernet2
no shutdown
interface Ethernet3
no shutdown
interface Ethernet4
no shutdown
interface Ethernet5
no shutdown
interface Ethernet6
no shutdown
interface Ethernet7
no shutdown
interface Ethernet8
no shutdown
interface Ethernet9
no shutdown
failover
failover lan unit primary
failover lan interface folink Ethernet0
failover link folink Ethernet0
failover interface ip folink 10.0.4.1 255.255.255.0 standby 10.0.4.11
failover group 1
primary
preempt
failover group 2
secondary
preempt
admin-context admin
context admin
description admin
allocate-interface Ethernet1
allocate-interface Ethernet2
config-url flash:/admin.cfg
join-failover-group 1
context ctx1
description context 1
allocate-interface Ethernet3
allocate-interface Ethernet4
config-url flash:/ctx1.cfg
join-failover-group 2
Example 12: Primary admin Context Configuration
enable password frek
password elixir
OL-10088-01
Example 12: LAN-Based Active/Active Failover (Transparent Mode)
Cisco Security Appliance Command Line Configuration Guide
B-31
Advertisement
Table of Contents
Troubleshooting
