Managed Switch Led Indicators; Configuring The Managed Ethernet Switch Module - GE D60 Instruction Manual

3 HARDWARE
The wiring for the managed Ethernet switch module is shown below.
Figure 3–47: MANAGED ETHERNET SWITCH MODULE WIRING
The 10/100Base-T and 100Base-FX ports have LED indicators to indicate the port status.
The 10/100Base-T ports have three LEDs to indicate connection speed, duplex mode, and link activity. The 100Base-FX
ports have one LED to indicate linkup and activity.
A suitable IP/gateway and subnet mask must be assigned to both the switch and the UR relay for correct operation. The
Switch has been shipped with a default IP address of 192.168.1.2 and a subnet mask of 255.255.255.0. Consult your net-
work administrator to determine if the default IP address, subnet mask or default gateway needs to be modified.
Do not connect to network while configuring the switch module.
GE Multilin
Connection speed indicator (OFF = 10 Mbps; ON = 100 Mbps)
Link indicator (ON = link active; FLASHING = activity)
Duplex mode indicator (OFF = half-duplex; ON = full-duplex)
Link indicator (ON = link active; FLASHING = activity)
Figure 3–48: ETHERNET SWITCH LED INDICATORS

3.4.4 CONFIGURING THE MANAGED ETHERNET SWITCH MODULE

D60 Line Distance Protection System
3.4 MANAGED ETHERNET SWITCH MODULES

3.4.3 MANAGED SWITCH LED INDICATORS

842868A2.CDR
3
3-43