Control Elements; Overview; Trip Bus - GE D60 Instruction Manual

5.7 CONTROL ELEMENTS

5.7CONTROL ELEMENTS
Control elements are generally used for control rather than protection. See the Introduction to Elements section at the
beginning of this chapter for further information.

PATH: SETTINGS CONTROL ELEMENTS
 TRIP BUS 1

5
The trip bus element allows aggregating outputs of protection and control elements without using FlexLogic™ and assign-
ing them a simple and effective manner. Each trip bus can be assigned for either trip or alarm actions. Simple trip condition-
ing such as latch, delay, and seal-in delay are available.
The easiest way to assign element outputs to a trip bus is through the EnerVista UR Setup software A protection summary
is displayed by navigating to a specific protection or control protection element and checking the desired bus box. Once the
desired element is selected for a specific bus, a list of element operate-type operands are displayed and can be assigned
to a trip bus. If more than one operate-type operand is required, it may be assigned directly from the trip bus menu.
5-206


TRIP BUS

TRIP BUS 1
FUNCTION: Disabled
TRIP BUS 1 BLOCK:
MESSAGE
Off
TRIP BUS 1 PICKUP
MESSAGE
DELAY:
TRIP BUS 1 RESET
MESSAGE
DELAY:
TRIP BUS 1 INPUT 1:
MESSAGE
Off
TRIP BUS 1 INPUT 2:
MESSAGE
Off
TRIP BUS 1 INPUT 16:
MESSAGE
Off
TRIP BUS 1
MESSAGE
LATCHING: Disabled
TRIP BUS 1 RESET:
MESSAGE
Off
TRIP BUS 1 TARGET:
MESSAGE
Self-reset
TRIP BUS 1
MESSAGE
EVENTS: Disabled
D60 Line Distance Protection System

TRIP BUS 1(6)
Range: Enabled, Disabled
Range: FlexLogic™ operand
Range: 0.00 to 600.00 s in steps of 0.01
0.00 s
Range: 0.00 to 600.00 s in steps of 0.01
0.00 s
Range: FlexLogic™ operand
Range: FlexLogic™ operand
↓
Range: FlexLogic™ operand
Range: Enabled, Disabled
Range: FlexLogic™ operand
Range: Self-reset, Latched, Disabled
Range: Enabled, Disabled
5 SETTINGS

5.7.1 OVERVIEW

5.7.2 TRIP BUS
GE Multilin