Oscillography; Data Logger; Phasor Measurement Unit Records - GE D60 Instruction Manual

6 ACTUAL VALUES

PATH: ACTUAL VALUES RECORDS
 OSCILLOGRAPHY

MESSAGE
MESSAGE
MESSAGE
MESSAGE
This menu allows the user to view the number of triggers involved and number of oscillography traces available. The
value is calculated to account for the fixed amount of data storage for oscillography. See the Oscillog-
CYCLES PER RECORD
raphy section of chapter 5 for additional details.
A trigger can be forced here at any time by setting "Yes" to the
menu for information on clearing the oscillography records.
CLEAR RECORDS

PATH: ACTUAL VALUES RECORDS
 DATA LOGGER

MESSAGE
The represents the time at which the oldest available samples were taken. It will be static until the log
OLDEST SAMPLE TIME
gets full, at which time it will start counting at the defined sampling rate. The
most recent samples were taken. It counts up at the defined sampling rate. If the data logger channels are defined, then
both values are static.
Refer to the 
COMMANDS CLEAR RECORDS

PATH: ACTUAL VALUES RECORDS
 PMU
 RECORDS
MESSAGE
The number of triggers applicable to the phasor measurement unit recorder is indicated by the
The status of the phasor measurement unit recorder is indicated as follows:
GE Multilin


OSCILLOGRAPHY

FORCE TRIGGER?
No
NUMBER OF TRIGGERS:
0
AVAILABLE RECORDS:
0
CYCLES PER RECORD:
0.0
LAST CLEARED DATE:
2000/07/14 15:40:16


DATA LOGGER

OLDEST SAMPLE TIME:
2000/01/14 13:45:51
NEWEST SAMPLE TIME:
2000/01/14 15:21:19
menu for clearing data logger records.

PMU RECORDS
NUMBER OF TRIGGERS:
0
 PMU 1
 RECORDING
D60 Line Distance Protection System
Range: No, Yes
command. Refer to the
FORCE TRIGGER?
NEWEST SAMPLE TIME

6.4.5 PHASOR MEASUREMENT UNIT RECORDS

Range: 0 to 65535 in steps of 1
See below.
6.4 RECORDS
6.4.3 OSCILLOGRAPHY

COMMANDS
6.4.4 DATA LOGGER
represents the time the
value.
NUMBER OF TRIGGERS
6-21
6